Features of Step2tub Bathtub Safety Step Stool
- Non-slip bath step
- Safe and Secure
- Made of industry-grade steel
- Portable and lightweight
- Dimensions: 32″ x 11″ x 12.5″
- Extra-wide landing base
- Step dimension: 12.5’’ x 11’’
- Reduces the risk of slips, falls, or trips
- Perpendicular handrails padded for extra grip and support
- Height adjustable grab bar
- Dual Clamp System
- This bath safety stool aids in the prevention of falls and allows users to bathe independently
- Compatible with most standard bathtubs
What to buy with Step2tub Bath Step Stool
- Safety Treads
- Inflatable Bath Cushion
- Drive Chrome Knurled Grab Bar
How to assemble Bathtub Stool?
- Place all parts on a flat working surface. Remove all plastic wrap, corner step protectors, and foam wrapping before assembly.
- Slide the legs into the base of the step stool, making sure the brass tension tabs lock into place.
- Repeat the process with all four legs and set the step stool upright.
- Prior to inserting the two handles into the legs, remove the circular black end pieces (as shown in picture below) on just the back side of the grab bars where the rounded clamp bars will slide into (you only need to remove a total of two of those pieces). Then, slide the rounded clamp bars (facing downwards towards the floor) onto each grab bar in an upward motion. Make sure these round-shaped bars are facing the back of the unit. Next, place the circular black end pieces the two you just removed) back onto the bottom of the grab bars just below the rounded-clamped bars. Now, insert the two handles into the legs making sure the handles are the same height by pushing in the brass tab adjustments. Please ensure that the holes are aligned properly on both sides, as the holes of each bar need to be facing outwards.
- To adjust height, press in each brass tab on each leg to adjust the height of the leg making sure all four legs are the same height. The legs are adjustable to three positions by 1″ increments.
- Customize height of the step2tub in increments of 1″ and the handle by 1/2″.
- Apply both bathtub grab bars to the bathtub using the step2tub to properly measure and determine the correct alignment. Once they are aligned, tighten both bars as firmly as possible to ensure maximum stability. Twist handle to tighten by hand.
- Lower the rounded bars on top of the bathtub grab bars and push the poles firmly into place. Please be sure to double-check that the unit is firmly attached to the bathtub.
How to use Step2Tub Bathtub Step with Handle?
4 Steps to get in tub:
Approach step2tub, grab firmly onto each bar with both hands. Please be sure to balance yourself prior to stepping up on to the base.
